National Hotline:+86-0510-85527866

Location: 首页 > Products > stainless steel coil & strip > 201 stainless steel coil
stainless steel coil & strip

201 stainless steel coil

201 stianless steel coil

201 is a high performance austenitic stainless steel that combines good mechanical properties, corrosion resistance, formability, fabrication, and welding characteristics and is similar in many respects to 304 stainless steel. The substitution of manganese for a portion of the nickel content used in 300 Series Stainless Steels can also make the use of 201 alloy more cost effective for many applications. Although a slight reduction in corrosion resistance may be a factor given 201 alloy’s lower chromium content, 201 is capable of providing corrosion resistance equivalent to 301 and 304 in most environments. 

            Emailsunny@haoguangsteel.com

ContactsSunny Wu

Mobile 86-13306186776


Application
Cooking Utensils                    
Restaurant Equipment
Appliances               
Automotive Trim
Architectural Applications

corrosion resistance

The general level of corrosion resistance of Type 201 is similar to Type 301. Type 201 should perform adequately as a replacement for 
Type 301, in most mild environments. The scaling resistance of Type 201 is less than that of Type 301. Type 201 resists destructive scaling up to about 1500 °F (816 °C), about 50 °F (28 °C) less than Type 301. 
fabrication
Type 201 Stainless Steel can be fabricated by bench forming, roll forming and brake bending in much the same manner as Type 
301. However, because of its higher strength, it may exhibit greater springback. This material can be drawn similarly to Type 301 in most 
drawing operations if more power is used and the hold-down pressure is increased.

 

Weldability

The austenitic class of stainless steels is generally considered to be weldable by the common fusion and resistance techniques. Special 
consideration is required to avoid weld “hot cracking” by assuring formation of ferrite in the weld deposit. As with other chrome-nickel 
austenitic stainless steel grades where carbon is not restricted to 0.03% or below, the weld heat affected zone may be sensitized 
and subject to intergranular corrosion in some environments. This particular alloy is generally considered to have poorer weldability to 
the most common alloy of this stainless class, Type 304L Stainless Steel. When a weld filler is needed, AWS E/ER 308 is most often 
specified. Type 201 Stainless Steel is well known in reference literature and more information can be obtained in this way. 



Heat treatment

Type 201 is not hardenable by heat treatment. Annealing: Anneal at 1850 – 1950 °F (1010 – 1066 °C), then water quench or rapidly air cool. The annealing temperature should be kept as low as possible, consistent with the desired properties, because Type 201 tends to scale more than Type 301

Online Inquiry:
*
*
*

Related suggestion

Leave a Message